Printer Driver Already Installed; For Windows Nt ® 4.0 Users; Installing The Tcp/Ip Protocol - Brother MFC 9420CN - Color Laser - All-in-One User Manual

Printer driver already installed

If you have already installed the printer driver and wish to configure it for network printing, follow these steps:
1
Select the printer driver you wish to configure.
2
Select File and then Properties.
3
Click the Ports tab of the driver and click Add Port.
4
Select the port that you wish to use. Typically this would be Standard TCP/IP Port. Then click the New
Port... button.
5
The Standard TCP/IP Port Wizard will start. Follow steps 8 to 12 of Printer driver not yet installed on
page 4-2.
6
Close Add Port and Properties dialog box.
For Windows NT
®
Windows NT 4.0 users can send print job using Brother Peer-to-Peer Print software provided on the Brother
CD-ROM supplied with the machine.

Installing the TCP/IP protocol

If you did not install the TCP/IP protocol during the installation of your Windows NT
workstation or server) follow these steps. If you have already installed the TCP/IP protocol, proceed to the
next section, Installing the Brother Peer-to-Peer software on page 4-4.
1
Go to the Start button, select Settings, and then Control Panel.
2
Run the Network applet by double clicking the Network icon and then click the Protocols tab.
3
Select Add, and double click TCP/IP Protocol.
4
Insert the requested disk(s), or CD-ROM, to copy the required files.
5
Click Close. The Windows NT
Properties dialog.
6
Configure the host IP address, subnet mask, and gateway address in that dialog. Consult your system
manager for these addresses.
7
Click OK to exit (your Windows NT
®
4.0 users
®
4.0 system will review protocol bindings and then you will see the TCP/IP
®
4.0 workstation or server will need to be re-booted).
®
4.0 system (either
4 - 3
4