GE Monogram ZKD910 Owner's Manual page 12

Before You (;all For Service...
Ele_lri_ I>/?_rming Drawer
Save time
and money
t_view the
troubleshooting
tips on this
page first and
you may not
need to call
jbr s_vice.
PROBLEM POSSIBLE CAUSE
WARMING DRAWER
WILL NOT WORK
DRAWER DOES NOT
SLIDE SMOOTHLY
OR DRAGS
_LXCESSIVE
CONDENSATION
• A fllse in your home mav be blown or the circuit breaker
tripped.
Replace the fllse or reset the circuit breaker.
• _,lrlning drawer not plugged ill. Plug ill.
• X4._rlniI_g drawer controls imi)roi)erly set. See the Using the
X_,lrlning Drawer section.
• Ball bearings are out of alignmelm Fully extend the drawer and
push it all the way in. See the Care and (_lealfing section.
• Drawer ovelqoaded or load ui_balanced. Reduce weight to less than
50 l)ounds. Redistribute drawer contents.
I,iquid ill warnling drawer. Renlove liquid.
Uncovered fl)ods. Cover fl)od with lid or alunfilmm fl)il.
NO HEAT IN THE •
PRO OF SETTING
FOOD DRIES OUT • Moisture escaping. Coxer food with lid or alunfilmm flfil.
Telnl)erature setting too high. Reduce teml)erature setting.
h_correct Moisture Selector setting. Set the Moisture Selector to
the open vent setting to allow venting.
Rooln temperature may l)revent the thermostat fl'om tril)l)ing oil
Tui'i_ the knob to LOW then back to PROOE
12