Temperature Controls - GE 23 Owner's Manual And Installation

About the temperaturecontrols, gecom
J
The temperature controls are preset in the factory at 37°F for the
refrigerator compartment and O°Ffor the freezer compartment. Allow
24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
Setting either or both controls to OFFstops cooling in both the freezer
and refrigerator compartments, but does not shut off electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
Tochange the temperature, press and release the
WARMER or COLDERpad. Tile SETlight will come
on and tile display will show tile set teml)eramre.
To change tile teml)eratm'e, tap either tile
WARMER or COLDER
pad
tlntil tile desired
temperature is displayed. Refl'igerator temperatures
can be ac!justed between 34°F and 44°F and tile
fl'eezer teml)eratm'es can be a(!iusted between
-()°F and +6°E
Once tile desired temperature has been set,
tile temperatm'e display will retm'n to tile actual
reflJgerator and fl'eezer temperatm'es alter 5
seconds. Several
a(!iusunents may
be required.
Each time you a(!iust controls, allow 24 hom_ fin" tile
refl_igerator to reach tile temperatm'e you have set.
Toturn the cooling system off, tap tile WARMER pad
fi)r either tile refl-igerator or tile fl'eezer tmtil tile
display shows OFF.To turn the unit back on, press tile
COLDERpad fin" either tile refl_igerator or fl'eezex:
The SETlight will ilhmfinate on the side you
selected, Then press the COLDERpad again (on the
side where the S_"Tlight is ilhmfinated) and it will
go to tile preset points
ot O°Ffi,r tile fl'eezer
and
37°Ffln" the reti'igeratox: Setting either or both
controls to OFFsmps cooling in both the fl'eezer
and refl'igerator compartments, but does not shut
off' electrical power to tile reli'igerato_:
Performance Air FlowSystem
Tile Perfimnance _M>glow System is designed to
maximize temperatm'e control in tile refligerator
and fl'eezer
compartments. This mfique special
teature consists of tile :Mr Tower
along tile back
wall ot the refl-igerator and the _dr Tmmel on the
bottom portion of tile fl'eezer rear wall. Placing fi)od
in fl'ont of the louvers on these components will not
affect pettommnce. _dthough tile :Mr Tower and
tile _dr Tmmel can be removed, doing so will affect
temperatm'e pe_tormance. (For remox_fl
instructions, on-line, 24 horns a day, contact us at
ge.com or call 800.GE.CARES. In Canada, contact
us at geappliances.ca or call 1.800.361.3400.)