Connecting With Your Devices - Epson 8100 Operating Manual

Setting up

Connecting with your devices

Before connecting them, make sure that the devices are suitable to connect with
this projector, and prepare the required signal cables and adapters. Consult your
dealer if the accessory that is not included in this product is required. Refer to the
following for connection. If you want to use the cable cover, see the Using the
cable cover (13).
Monitor
WARNING
recommended by your dealer. Do not modify the projector or accessories.
►For the cable with a ferrite core only at one end, connect the end with the core
to the projector. The cables may be required a specific length or a ferrite core by
the regulations.
►Be careful not to damage the cables. Route the cables so that they are not
likely to be walked on or pinched by items placed upon or against them.
CAUTION
they are connected to a power supply, except for the cases directed by the
manuals.
►Be careful not to set a connector into a wrong port or with a wrong way.
(continued on next page)
0
USB-A RS-232C
RGB IN
CONTROL
Y C /P C /P
B B R R L R
COMPONENT VIDEO OUT
AUDO OUT
►Use only the accessories contained in this product or
►Do not connect or disconnect the projector with devices while
PCs
AUDIO
RGB OUT RGB OUT
OUT
MONITOR OUT COMPUTER IN2 COMPUTER IN1
USB S-VIDEO
AUDIO IN
Y C /P C /P
B B R R
VIDEO L R
AUDIO IN3
VIDEO L R
S-VIDEO
OUT AUDO OUT
OUT
AUDIO
LAN
OUT
AUDIO IN
Speakers
LAN
1
(with an amplifier)
AUDIO
OUT
2
VCR/DVD
L R
players
AUDO OUT