Channel Set Up; Deleting (Or Adding) Channel(S) - Emerson EWC19T4 Owner's Manual

CHANNEL SET UP

You can program the tuner to scan all the channels
you receive in your area.
NOTE:
Channel memory programming is NOT needed when
connected to a cable box or satellite box. Just select
the unit's channel selector to the output channel of
the cable box or satellite box (Ex CH3), then select
the channel to be viewed on the Cable Box or
Satellite Box.
Make sure ...
•
Press the POWER button to turn on the unit.
1
Select "CHANNEL SET UP"
Press the SETUP button on the
remote control.
Press the Arrow button K or L to
point to "CHANNEL SET UP".
Then press the ENTER button.
2
Begin auto ch programming
Press the Arrow button K or L to
point to "AUTO CH PROGRAM-
MING".
Then press the ENTER button.
The tuner scans and memorizes all
the active channels in your area.
3
After scanning
The tuner stops on the lowest memorized channel.
•
When AUTO CH PROGRAMMING is activated
where there is no TV signal input, "NO TV SIG-
NALS" will appear on the display after the com-
pletion of the channel scanning.
•
The unit may recognize TV channels to be CATV
channels by the receiving conditions. In this case,
try AUTO CH PROGRAMMING again in the fine
receiving conditions.
TV/VCR
The channels you no longer receive or seldom watch
can be deleted from the memory. (Of course, you
can add the deleted channel into the memory again.)
1
Press the SETUP button on the
remote control.
Press the Arrow button K or L to
point to "CHANNEL SET UP".
Then press the ENTER button.
2
Press the Arrow button K or L to
- TV/VCR SETUP -
TIMER PROGRAMMING
SETTING CLOCK point to "ADD/DELETE CH".
B CHANNEL SET UP
USER'S SET UP
V-CHIP SET UP Press the ENTER button.
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
3
Press the Arrow button K or L
until your desired channel number
– CHANNEL SET UP –
appears. (You can also use the
ADD / DELETE CH (CATV)
number buttons or the CHANNEL
B AUTO CH PROGRAMMING
button K or L to enter it)
(Example: CH8)
•
You must precede single-digit channel numbers
with a zero (Example: 02 ... 09).
•
When selecting cable channels which are higher
than 99, press the +100 button first, then, press the
last two digits. (Example: to select channel 125,
first press the +100 button then press "2" and "5").
4
Press the ENTER button. The channel number
changes to light red. The channel is deleted from
memory.
•
To delete another channel, repeat steps [3] to [4].
•
If you press the ENTER button again, the channel
is memorized again.
Added channel: Light blue
Deleted channel: Light red
5
Press the SETUP button on the remote control to
return to TV mode.
NOTE:
To confirm that channel(s) has been deleted or
added, press the CHANNEL button K or L.
- 18 -
DELETING (OR ADDING)
CHANNEL(S)
Select "CHANNEL SET UP"
Select "ADD/DELETE CH"
Enter the desired channel number
Delete (or add) it from (or into) memory
Exit the channel setup mode
TV/VCR
- TV/VCR SETUP -
TIMER PROGRAMMING
SETTING CLOCK
B CHANNEL SET UP
USER'S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
– CHANNEL SET UP –
B ADD / DELETE CH (CATV)
AUTO CH PROGRAMMING
08
ADD / DELETE
EN
1C29