Jmicron ® Raid Configuration; Before Creating A Raid Set - Asus P5K PREMIUM/WIFI-AP - Pearl Special Edition Motherboard User Manual

5.4.3 JMicron
The JMicron ®
JBOD sets on the external Serial ATA hard disk drives.

Before creating a RAID set

Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk (Windows XP). A write-enabled floppy disk or a
USB flash disk drive (Windows Vista)
3. Microsoft
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install the two external Serial ATA hard disk drives to your system.
Set the Controller Mode item in the BIOS to [RAID]. See section 4.4.5
2.
Onboard Devices Configuration for details.
Advanced
Onboard Device Configuration
High Definition Audio
Front Panel Type
J-Micron eSATA/PATA Controller
Controller Mode
Realtek GigaBit LAN
LAN Boot ROM
Marvell GigaBit LAN
LAN Boot ROM
Realtek Wireless LAN
Agere Firewire 1394
Serial Port1 Address
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
section 5.5 Creating a RAID driver disk for details.
5. Install the JMB363 driver after the Windows
Always install the JMB363 driver before creating RAID sets.
5-42
RAID Configuration
®
Serial ATA controller allows you to configure RAID 0, RAID 1 and
Windows OS installation disk (Windows 2000/XP)
® ®
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
BIOS SETUP UTILITY
[Enabled]
[HD Audio]
[Enabled]
[RAID]
[Enabled]
[Disabled]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
® OS had been installed.
Enable or Disable
High Definition Audio
Controller
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
® OS installation. Refer to
Chapter 5: Software support