Table of Contents
Advertisement
5.4.3
JMicron
The JMicron
®
on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1.
Two HDDs, preferably with the same model and capacity.
2.
A write-enabled floppy disk
3.
Microsoft
4.
Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1.
Install the external Serial ATA hard disk drives (HDDs) on your system.
2.
Set the JMicron Controller Mode item in the BIOS to [RAID]. See section
"4.4.6 Onboard Devices Configuration" for details.
Advanced
Configure Win627EHF Super IO Chipset
HD Audio Controller
Front Panel Support Type
Onboard 1394 Controller
Onboard PCIE GbE LAN_1
Onboard PCIE GbE LAN_2
LAN Option ROM
JMicron SATA/PATA Controller [Enabled]
JMicron Controller Mode
JMicron SATA/RAID BOOTROM [Enabled]
Serial Port1 Address
3.
Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4.
Create a JMB363 RAID driver disk for Windows
"5.5 Creating a RAID driver disk" for details.
5.
Install the JMB363 driver after the Windows
5-0
RAID Configuration
®
Serial ATA controller allows you to configure RAID 0 and RAID 1 sets
Windows
OS installation disk (Windows 2000/XP/2003)
®
®
[Enabled]
[HD Audio]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[RAID]
[3F8/IRQ4]
v02.58 (C)Copyright 1985-2005, American Megatrends, Inc.
BIOS SETUP UTILITY
OS had been installed.
®
Options
Enabled
Disabled
Select Screen
Select Item
+-
Change Option
F1
General Help
F10
Save and Exit
ESC
Exit
OS installation. See section
®
Chapter 5: Software support
Advertisement
Table of Contents
