36 electrolux what to do if...
What to do if...
Remedying small malfunctions
If, during operation, the error code (E
plus number or letter) appears on the
multi-display: Switch the appliance off
and on again. Reset programme. Press the
START/PAUSE (INICIO/PAUSA) button.
Problem
Washing machine does
not work.
Drum light is not working.
Iron Aid programme does
not start.
After an Iron Aid pro-
gramme, garments are
not sufficiently smooth.
After an Iron Aid pro-
gramme, there are no
creases left in the gar-
ments.
Possible cause
Mains plug is not plugged in or
fuse is not working correctly.
Door is open.
Press the START/PAUSE (INI-
CIO/PAUSA) button.
Programme selector in O OFF
position.
Defective light bulb.
Water tank is empty.
Wrong programme selected
(e.g.
SYNTHETICS -
SINTÉTICOS instead of
COTTON - ALGODÓN).
Too low a LOAD (CARGA)
steam level set.
Too many garments in machine,
or garments that are too differ-
ent.
Clothes are not removed until
the anti-crease phase is fin-
ished.
Garments not hung on clothes
hangers and/or not tugged into
shape.
Multi-layered garments tend to
lose their shape.
The Iron Aid programme has
the effect of smoothing gar-
ments.
If the error appears again, please con-
tact the Customer Care Department,
stating the error code.
Plug in at mains socket. Check
fuse in fuse box (domestic installa-
tion).
Close door.
Press the START/PAUSE (INICIO/
PAUSA) button.
Turn the programme selector to
any programme.
Replace light bulb (see next sec-
tion).
Fill water tank.
Note the composition of the fabric.
Set a higher LOAD (CARGA)
steam level.
Load the machine with fewer gar-
ments, or only similar ones.
Remove clothes quickly one at a
time from the machine as soon as
possible after the start of the anti-
crease phase.
Hang garments on clothes hang-
ers, do up buttons and tug gar-
ments into shape.
Reshape multi-layered garments
by ironing after they come out of
the machine.
Iron creases in again after the Iron
Aid programme.
Remedy