Mechanical Specifications - Seagate ST32430N - Hawk 2.1 GB Hard Drive Product Manual

Product Manual - Hawk 2LP Family SCSI-2 (Volume 1), Rev. A
_____________________________________________________________________________________
7.6

Mechanical specifications

The following nominal dimensions are exclusive of the decorative front panel accessory. However, dimensions
of the front panel are shown in figure below. Refer to Figure 7.6-1 for detailed mounting configuration
dimensions. See section 7.6.3, Drive mounting.
Height:
Width:
Depth:
Weight:
[3]
C
[1]
J
[2]
H
K
N
[4]
Figure 7.6-1. Mounting configuration dimensions
1.00 in 25.4
4.00 in 101.6
5.74 in 145.8
1.5 pounds
G
D
F
A
Notes:
[1] Mounting holes three on each side, 6-32 UNC. Max
[2] Mounting holes four on bottom, 6-32 UNC. Max
B
[3] Power and interface connectors can extend
[4] Decorative front panel (optional).
P
M
mm
mm
mm
0.68 kilograms
[4]
L
E
screw length into side of drive 0.15 in. (3.81 mm).
Screw tightening torque 6.0 in-lb (.675 NM) max with
minimum thread engagement of 0.12 in. (3.05 mm).
screw length into bottom of drive 0.20 in. (5.08 mm).
Screw tightening torque 6.0 in-lb (.675 NM) max with
minimum thread engagement of 0.12 in. (3.05 mm).
past the "A" dimension by 0.040 in. (1.02 mm).
Inches
A 5.74 ± .010
B 4.00 ± .010
C 1.00 + .026
– .010
D 2.362 ± .010
E .620 ± .010
F 4.000 ± .010
G .250 + .010
– .005
H 1.750 ± .010
J 3.750 ± .010
K 2.370 ± .010
L 1.00 ± .010
M 4.000 ± .010
N 0.19 ± .010
P 0.015 max
Millimeters
145.80 ± .25
101.60 ± .25
25.40 + .66
– .25
60.00 ± .25
15.75 ± .25
101.60 ± .25
6.35 + .25
– .12
44.45 ± .25
95.25 ± .25
60.20 ± .25
25.4 ± .25
101.6 ± .25
4.83 ± .25
0.381 max
25