Main Menu (Ag)-Operating Status; Main Menu (Ag)-View/Set Control Setpoints; Main Menu (Ag)-Setup System; Table 8 Default Control And Alarm Setpoints - Emerson Liebert Deluxe System/3 DE Operation And Maintenance Manual

4.5 Main Menu (AG)—Operating Status
The Operating Status is intended to provide the user with displayed information concerning what the
control is calling for the system to do.
NOTE
There may be some time lapse before a specific component matches the displayed number.
For example: The display indicates the chilled water valve is 68% open. On a new call for cooling, it
takes several seconds for the valve to travel from full closed to 68% open. So when the display reads
68%, it may take a few seconds for the valve to actually open 68%. Also, if the display indicates a com-
pressor is operating but the compressor has not turned on yet, it may be off because of the short cycle
control (see 5.3.1 - Short Cycle Control).
4.6 Main Menu (AG)—View/Set Control Setpoints
Control setpoints can be reviewed and/or changed through the display. The following table lists the
default setpoints and their allowable ranges.
Table 8 Default control and alarm setpoints
Setpoint
Temperature Setpoint
Temperature Sensitivity
Humidity Setpoint
Humidity Sensitivity
High Temperature Alarm
Low Temperature Alarm
High Humidity Alarm
Low Humidity Alarm
*Unit will operate at these conditions but will not control to these extremes of conditions.
4.7 Main Menu (AG)—Setup System
Selecting SETUP SYSTEM will step to the following menu:
• SETUP OPERATION
• SELECT OPTIONS
• CALIBRATE SENSORS
• CALIBRATE VALVE ACTUATOR
• SELECT CONTROL ALGORITHM
• SELECT HUMIDITY SENSING MODE
• SET STATUS DISPLAY
• CHANGE PASSWORDS
Default Range*
72°F 40 to 90°F (5 to 32°C)
2.0°F 1 to 9.9°F (0.6 to 5.6°C)
50% 20 to 80% RH
5% 1 to 30% RH
80°F 35 to 95°F (2 to 35°C)
65°F 35 to 95°F (2 to 35°C)
60% 15 to 85% RH
40% 15 to 85% RH
23
Advanced Microprocessor with Graphics Control Setup