Operating Your Air Conditioner; Remote Control - Emerson EARC5RD1 Owner's Manual

1
3
4
5
6
3
1. Power: Turn the air conditioner on and off.
2. Cool: Press the COOL button to COOL mode.
3. and : Use these buttons on the control
panel and remote to increase or decrease the
Set Temperature or Timer. Temperature range:
61 ~88 or 16 ~31 .
4. Sleep: Press the SLEEP button, the Sleep
Light will be on after 10s. and the remaining
lights on the display will be off. In SLEEP mode,
the air-conditioner will automatically adjust the
temperature and fan speed to make the room
more comfortable during the night. The set
temperature will automatically raise by 1
every 30-60minutes and at most change six
times until the set temperature is 28
And every Run time will depend on set
temperature.
5. Timer:
and remote to set the TIMER.
Timer Off: The timed stop is programmed by
pressing TIMER button. Set the
pressing the button
desired stop time is displayed, then press TIMER
button again.
2
Timer On:
button first
the button
a second time, set the stop time
button
7
third time, confirm your settings and stop time.
The display will show the time your machine will
8
automatically turn on.
Note: It can be set to automatically turn off or on in
9
0.5-24 hours. Each press of the
buttons will increase or decrease the timer. The
10
Timer can be set in 0.5 hours increment below 10
hours and 1 hour increment for 10 hours or above.
The SET light will turn on while setting.
To cancel the set function, press the TIMER button
again.
6. Auto Mode:
chooses the fan speed and the mode of operation
(COOL, DRY, or FAN). In this mode the fan speed
and the temperature are set automatically
according to the room temperature (
temperature is determined by the temperature
sensor located in the indoor unit.
7. Fan Speed:
to select the fan speed. In COOL MODE you can
choose the following settings: HI, MED, LO, or
AUTO. In FAN MODE you can choose from HI,
MED, and LO.
8. Display:
switch off/on all lights or LED display.
9. Eco:
light will turn on. In ECO mode, the unit will
turn-off once the room is cooled to the user set
temperature. The fan will also be off at this point.
The unit will turn back on when the room
temperature rises above the user set temperature.
Before the compressor stars, the fan motor will
run for a while, then it will stop for a while-and will
repeat to provide a much more comfortable-feeling
and save energy.
.
10. Fan Only:
ONLY mode.
9
Use buttons on the control panel
or
When the unit is off, press TIMER
, set the temperature with pressing
or .
or . Press TIMER button a
In AUTO mode the unit automatically
Press the FAN SPEED button
To press the DISPLAY button, it can
When the unit is in ECO mode, the
Press the Fan Only button to FAN
stop
time by
until your
Press TIMER button
with pressing the
Room
).