High Frequency; Power Saver Mode - Viper ESP 540 Owner's Manual

High Frequency

Your system transmits and receives at 434 MHz. This provides a cleaner
spectrum with less interference and a more stable signal. Enjoy a phe-
nomenal increase in range, even in areas with high radio interference.

Power Saver Mode

Your system will automatically enter Power Saver Mode while armed
or in Valet ® Mode, after a period of time in which no operation has
been performed. This lowers the current draw on the vehicle's bat-
tery and prevents the system from draining the battery. Power
Saver Mode takes over under the following conditions:
s
Power Saver when the system is armed: After the system has
been armed for 24 hours the LED will flash at half its normal
rate, decreasing the system's current draw.
s
Power Saver in Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one hour period while the
system is in Valet
remains in Valet
time the ignition is turned on and then back off.
24
® Mode: When the system enters Valet
® Mode, the LED will shut off. If the system
® Mode, the LED will come back on the next
1999 Directed Electronics, Inc.
©
®