Table of Contents
Advertisement
Control
Panel
Door
Heat Vents
(Behind Door)
Front Glass
Carefully remove unit from box. Prior to per-
manently installing unit, test to make sure unit
operates properly. Unit does not come with a
power cord installed. Unit must be hard wired
to either a 120/60 or 240/60 volt supply.
CAUTION; The unit must
be connected to a properly
grounded and protected 120/240
volt circuits. Always use ground
fault protection where required
by the electrical code.
WARNING: Due to high tem-
peratures, this heater should
be located out of traffic. Keep
combustible materials such
as furniture, pillows, bedding,
papers, clothes and curtains at
least 3 feet (0.9 m) from the front
of the heater.
WARNING: Never locate this
heater where it may fall into a bath-
tub or other water container.
4
PRODUCT IDENTIFICATION
Log Set
Figure 2 - Product Identification
UNPACkINg AND TESTINg
LOCATINg FIREPLACE
www.desatech.com
Remote Hide
Heater
Flame
Ember
Heater
Control
ON/OFF
Power
Button
WARNING: Do not operate
the unit if it is damaged or has
malfunctioned. If you suspect
the unit is damaged, return the
unit to an authorized service
facility for examination, electri-
cal or mechanical adjustment
or repair.
NOTICE: Minimum and maximum
clearances must be maintained at
all times. Illustrations throughout
these instructions reflect typical
installations and are for design
purposes only. Actual installa-
tions may vary slightly due to
individual preferences.
WARNING: To prevent
contact with sagging or loose
insulation, the heater must not
be installed against vapor barrier
or exposed insulation. Localized
overheating could occur and a
fire could result.
Flame Control
Ember Control
Backlight
Control
Backlight
Power
Magnetic
Catch
122663-01D
Advertisement
Table of Contents
