dbx DriveRack 260 User Manual page 63

DriveRack
Zone Controller Wiring
The DriveRack 260 Zone Controllers, (ZC-1, ZC-2, ZC-3, ZC-4) can be wired serially or in par-
allel. To wire in series each Zone Controller must have an identification or zone number cho-
sen using the DIP switches on the side of the controller (see diagram A). Each controller must
have a unique number chosen although there may be multiple Zone Controllers controlling a
single zone, or a single Zone Controller that controls multiple outputs. The Zone Controllers
can then be wired together and connected to the DriveRack 260 (see diagram B).
The Zone Controllers may also be wired in parallel with the use of the ZC-BOB. To wire in
parallel (home run cabling), each controller must have a unique identification or number cho-
sen using the DIP switches on the rear of the panel (see diagram A). To wire in parallel, each
controller must be wired into a port of the ZC-BOB with a connecting wire going to the
DriveRack 260 (see diagram C).
Diagram A
Diagram B
ID # 1 ID # 4
80- 1342-A 80- 1342-A
®
™
Remote Control
18 W A TTS
Use onl y wit h a 250V fu se
Emplo yer uni quem entavao
POW ER
un fu s i bl e de 250V
100V - 120V
A HARM AN I NTERNA TI ONAL
COM P ANY SAL T LAKE CI TY ,U TA H
M ODEL Drive Rack
COM PLETE
M ANAGEM ENT
50/ 60H z
PC ZON E C ONTROLL ER
SECTION 6
O UTPUTS O UTPU
M ADE I N USA
TM 260
EQ & LOUDSPEAKER
SYST EM
CH 6 CH 5 CH 4
480 User Manual 55