Adobe 25520388 - Premiere Pro - PC Using Manual page 194

USING ADOBE PREMIERE PRO
Editing sequences and clips
Timeline panel during (above) and after (below) a rolling edit
Make a rolling edit using the Trim Monitor
1 In the Trim Monitor, click the Select Video Or Audio Track button and select the track you want to edit.
Click in the Sync Lock box in the header of any track you want to shift when the rolling edit is made.
2
In a Timeline, place the current-time indicator at the edit point. This will display the edit point in the Trim Monitor.
3
4 Do any of the following:
• Position the pointer between the video images so that it changes into the Rolling Edit tool
right.
• Drag the center timecode display left or right.
• Drag the center jog disk left or right.
• Click the timecode display between the views, type a valid timecode number to trim the edges of both clips to that
frame, and press Enter (Windows) or Return (Mac OS).
• Select the boxed number above the center jog disk, type a negative number to trim both clips left or type a positive
number to trim both clips right, and press Enter (Windows) or Return (Mac OS).
• Click the button that corresponds with the number of frames you want to edit. The –1 and –5 buttons trim both
clips left; +1 and +5 trim both clips right.
Note: The large trim offset number is 5 frames by default, but you can set it to any number by specifying a number in the
trim preferences. Choose Edit > Preferences > Trim (Windows) or Premiere Pro > Preferences > Trim (Mac OS).
Make rolling edits with the current-time indicator
You can move the In point or Out point of a clip in a sequence to the current-time indicator or playhead, without
leaving gaps in the sequence. This type of editing is sometimes called extending an edit, or using extend edit
commands.
In Premiere Pro CS5, you first assign keyboard shortcuts in the Keyboard Customization dialog box. Then use the
designated keyboard commands to extend edits as rolling edits. The commands in the Keyboard customization are as
follows:
• Roll Previous Edit to CTI
• Roll Next Edit to CTI
These commands are available after you assign shortcuts to them from the Keyboard Customization dialog.
Last updated 1/16/2012
189
; then drag left or