Please Remember - Mitsubishi Daiya SKM22ZD-S User Manual

Please remember!

You cannot restart the unit immediately after you have
stopped it.
Air is not blown out when starting the HEATING operation.
Air is not blown out for 5 to 10 min. at HEATING operation.
Air is not blown out when starting the DRY operation.
Some steam escapes during COOL operation.
There is a slight smell.
You hear a slight gurgling sound.
You hear a slight cracking sound.
After a power cut, you cannot re-start, even if power has been re-
stored, unless you have the power blackout auto restart function.
Remote control signals are not received.
Moisture may form on the air outlet grilles.
FAN operation will be performed even if COOL, DRY, or
HEAT have been selected.
Whistling noise is heard from the outdoor unit.
Sometimes a "Shooooo" sound might come for a short time
from the unit that is turned off.
(RUN light is on)
Not
operating?
RUN light blinks slowly
(1.5 sec ON, 0.5 sec OFF)
RUN light blinks slowly
(1.5 sec ON, 0.5 sec OFF)
(RUN light is on)
– 18 –
Restarting has been blocked for 3 minutes after you have stopped or
after switching off the power during operation, to protect the unit.
Please wait for
three minutes.
The three-minute protection timer in the microcomputer automatically
starts up again.
Air flow has stopped to prevent blowing out of cold air until the indoor
heat exchanger has warmed up. (2 to 5 min.) (HOT KEEP)
When outdoor temperature is low and humidity is high, the unit some-
times performs defrosting automatically. Please wait. During defrost-
ing, water or steam may escape from the outdoor unit.
The indoor fan may stop to prevent re-evaporation of dehumified
moisture and to save energy.
This may occur if the room's temperature and humidity are very high.
It disappears as soon as the temperature and humidity decrease.
Air blown out during operation may smell. This is caused by tobacco
or cosmetics sticking to the unit.
This is caused by refrigerating liquid moving within the unit.
This is caused by heat expansion or contraction.
The memory circuit of the microcomputer has been wiped out. Use the
remote control to start the operation again.
Remote control signals may not be received if the signal receiver on
the air conditioner is exposed to direct sunlight or other bright light.
If so, cut out the sunlight or reduce the other light.
If the unit is operated for a long time in high humidity, moisture may
form on the air outlet grilles and start dripping.
If one unit is operating in COOL mode while another is in operating in
HEAT or any other different operation mode, FAN mode operation
will be implemented. Individual operation modes need to be matched.
The noise means that the revolution speed is picking up on the com-
pressor.
This is the sound when operation of another indoor unit is stopped.