SnapGear VPN appliance Family 1.7.8 User Manual page 10

The rear panel contains the connector ports for the LAN (LAN) and modem (COM1,
COM2), LAN 10BaseT status LEDs, WAN 10BaseT status LEDs, the reset button and
power inlet.
For units with LAN/Internet status LEDs, one LED represents the link condition (upper on
SME530, SME550 and PRO+, lower on PRO and SOHO+), where a cable is connected
correctly to another device (e.g. a cable modem). The other light represents the activity
as per the front panel.
Figure 1.2 SnapGear appliance back panels
The following figure shows how your SnapGear appliance interconnects . If you are using
the SnapGear LITE+ or LITE2+, a secondary hub/switch is not required as this unit has a
4-port Ethernet switch.
7
Introduction