Message Display - Dakota Digital 3X Series Installation And Operation Manual

MESSAGE DISPLAY

Since the VFD 3X systems use a shared message center for speed and tach messages
both Switch 1 (SW1) and Switch 2 (SW2) are used to cycle through the various messages. Use
SW1 to select different message screens (Mileage, Performance, Tach Bar). Use SW2 to
change between different readings within the same screen (Trip A, Trip B, Service or km/h,
Hours, Hi RPM). If any BIM modules are connected the information will be shown at the bottom
of the Tach Bar screen. Some typical display screens for the message display are:
Mileage screen with the GEAR menu turned ON. (requires optional GSS-2000)
Odometer
000000 A 000.0
P R N O D 2 1
Gear position with overdrive
Mileage screen with the GEAR menu shut OFF.
ODOMETR 000000
TRIP A 000.0
Tach Bar screen
Tach Bar (rpm x1000)
1 2 3 4 5 6 7 8
Km/h
Km/h conversion
Performance Screen
High speed recall
Wait, Brake, 4x4, and Engine indicators use reverse image letters in the message display corners when active.
W B x4 E
Available readings:
odometer reading (0-999,999)
trip A odometer reading (0-9999.9)
trip B odometer reading (0-9999.9)
distance since last service (0-9,999, or ---- when past due) (when enabled)
0-60 mph time in seconds (0-25.5) (when enabled)
high speed recall (0-255) (when enabled)
¼ mile time in seconds (0-25.5) (when enabled)
¼ mile trap speed (0-255) (when enabled)
kph conversion (or mph conversion if kph selected as primary unit)
high RPM recall (0-18,000)
hours system has been on with tach signal (0-999.9)
bar tach readout on message display (0-8,000)
gear shift position indicator (with purchase of optional GSS-2000)
BIM module messages will display in the message display as well
NOTE: In normal operation you have to use Switch 1 (SW1) to reset trip meters, service
counter, hour meter, high RPM, and the various performance timers. A press and hold
will zero the current reading, if resettable.
Trip A
000000 B 000.0
Odometer
ODOMETR 000000
Trip B
Trip A
1 2 3 4 5 6 7 8
00 Hours 000.0
Hour meter
0-60 time
00 0.0 0.0
HI 0-60 1/4
Trip B
P R N D 2 1
Gear position without overdrive
TRIP B 000.0
¼ mile time
00
HI 0-60
6
Service reading (when enabled)
000000 S 0000
P R N D 2 1
ODOMETR 000000
SERVIC 0000
Service reading
1 2 3 4 5 6 7 8
Hi RPM 0000
High RPM recall
¼ mile trap speed
0.0 00
1/4
MAN 650067:G