Terminal Descriptions - Dakota Digital 3X Series Installation And Operation Manual

Additional ground wire to fuel
sensor body or mounting screw.
EXISTING
FUEL LEVEL
SENSOR

TERMINAL DESCRIPTIONS

Status LED
This LED is located at the corner of the control box, next to the GROUND terminal. The
LED is used for diagnostics.
A steady flash, on and off, about one second apart indicates the system is powered and
operating normally.
On steady indicates low power, below 9V, at the POWER terminal (the displays will also
generally be dim).
Not flashing or lighting indicates loss of power or ground.
ECU/ECM
Check Engine
DISPLAY PANEL
RIBBON CABLE
DISPLAY
STRIPE RIBBON CABLE
SERIES III
VFD CONTROL BOX
www.dakotadigital.com
techsupport@dakotadigital.com
605-332-6513
PRESSURE SENSOR
SEN-03-8
0-100 PSI
TEMP SENSOR
SEN-04-5
100-300 F
DIM-1
Optional
Parking Brake
Switch
High Beam
Output
Wire
Left Turn
Right Turn
Signal Wire
Signal Wire
BIM
CONNECTION
ONLY!
AUX.
I/O
STATUS LED
Connect to main
chassis ground
Tail Light
Connect to tail light circuit
dash will dim when terminal has +12V
SPEED OUT
(2k or 4k PPM)
8
4x4
DAKOTA DIGITAL
Transfer Case
GSS UNIT
Switch
1-Wire output
Optional
Glow Plug Relay
or
Wait To Start
Output
Cruise Control
Engage Output
+12V
KEY ON POWER
(fused 5 - 20 AMP max)
- +
Ignition Coil
(negative side)
Light or Buzzer
ECU/ECM
Speed Output (4 Watts or less)
Relay
SPEED SENSOR
SEN-01-5
16k PPM
Light or Buzzer
(4 Watts or more)
MAN 650067:G
ECU/ECM
or Ignition Box
(tach output)