Administrator Login Name; Administrator Password; Remote Management; Administrator Settings - D-Link DIR-301 User Manual

Section 3 - Configuration
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management.
There are two accounts that can access the management interface through the web browser. The accounts are admin
and user. Admin has read/write access while user has read-only access. User can only view the settings but cannot
make any changes. Only the admin account has the ability to change both admin and user account passwords.
Administrator Enter a new Login Name for the Administrator account.
Login Name:
Administrator
Enter a new password for the Administrator Login
Password:
Name. The administrator can make changes to
the settings.
User Login Name:
Enter a new Login Name for the user account.
User Password:
Enter the new password for the User login. If you
login as the User, you can only see the settings,
but cannot change them.
Remote
Remote management allows the WBR-1310 to be
Management:
configured from the Internet by a web browser. A
username and password is still required to access
the Web-Management interface. In general, only
a member of your network can browse the built-in
web pages to perform Administrator tasks. This
feature enables you to perform Administrator
tasks from the remote (Internet) host.
The Internet IP address of the computer that has
IP Address:
access to the Broadband Router. If you input an
asterisk (*) into this field, then any computer will
be able to access the Router. Putting an asterisk
(*) into this field would present a security risk and is not recommended.
Port:
The port number used to access the WBR-1310.
Example: http://x.x.x.x:8080 whereas x.x.x.x is the WAN IP address of the WBR-1310 and 8080 is the port used for the
Web-Management interface.
D-Link DIR-301 User Manual

Administrator Settings

3