Snmp - D-Link DIR-455 User Manual

Section 3 - Configuration
SNMP (Simple Network Management Protocol) is a widely used network monitoring and control protocol that reports activity on each
network device to the administrator of the network. SNMP can be used to monitor traffic and statistics of the DIR-455. The DIR-455
supports SNMP v1 or v2c.
SNMP Local:
SNMP Remote:
Get Community:
Set Community:
IP 1, IP 2, IP 3, IP 4:
SNMP Version:
D-Link DIR-455 User Manual

SNMP

Select Enabled to allow local
SNMP administration. Select
Disabled to disallow local SNMP
administration.
Select Enabled to allow local
SNMP administration. Select
Disabled to disallow local SNMP
administration.
Enter the password public in this
field to allow "Read only" access
to network administration using
SNMP. You can view the network,
but no configuration is possible with
this setting.
Enter the password private in this field to gain "Read and Write" access to the network using SNMP
software.
Enter up to 4 IP addresses of any trap targets on your network.
Select the SNMP version of your system.
Click Save Settings to save your changes, or click Don't Save Settings to discard your changes.
SNMP
48