Change Date & Time/Automatic Daylight Saving Time; Factory Defaults; Table 12 Factory Default Settings - Liebert Liqui-tect MC68HC16Z1 User Manual

6.8.2 Change Date & Time/Automatic Daylight Saving Time
The Liqui-tect panel has a built-in, real-time clock that is backed up by an encapsulated lithium bat-
tery and set up to adjust automatically for daylight saving time twice a year. The Setup System Info
menu allows you to change the date or time or automatic adjustment at any time.
To change the daylight saving time setting, date or time:
• From the Setup System Info Menu, use the arrows
Change Date & Time, then press Enter .
• To change the daylight saving time setting:
• To the right of Daylight Svg Time? use the arrows
choose Y (Yes - automatically adjust for daylight saving time)
or N (No), then press Enter .
• The format of the date and time is DD-MMM-YY HR:MM:SS.
To change the date or time:
• Press Enter
want to change.
• Use the arrows
Date Day (DD)
Time Hour (HR)
• Press Enter
• When finished, press Enter
6.8.3

Factory Defaults

At any time, you may restore all default values for settings in the
Liqui-tect panel as it was shipped, as shown in Table 12.
The password is the sole exception when reverting to the factory
default settings. The password can be reset to the factory default of
AAAA only through the DIP switches. For details, see Change
Password on page 35.
Table 12 Factory default settings
Zones CONNECTED
1 & 2
LABEL
UNITS
AUTO CALIBRATE
SENSITIVITY FOR
WATER DETECT
SENSITIVITY FOR
CONTAMINATED
Alarm LONGEST CABLE LENGTH
outputs
LEAK & FAULT RELAYS:
NORMALLY OPEN/CLOSED
LEAK & FAULT ALARM:
LATCHED/UNLATCHED
Mapping
Current
values
Distance
Re-alarm
Delay in minutes
delay
to advance to the next character position you
to choose from available entries:
0-31
Month (MMM) JAN-DEC
Year (YY) 00-99
00-23
Minutes (MM) 00-59
Seconds (SS) 00-59
to advance to the next character position.
again.
Feature
to choose
to
Default
N (Not connected)
ZONE 1
FT (feet)
Automatic
150 UA
50 UA
0-1000 ft. (0-304.8m)
NO (Normally Open)
Y (Latched)
0UA, where UA represents µA
or microAmps
(none)
5 minutes
36
System and Control Options
Setup System Info Menu
SETUP SYSTEM INFO
CHANGE PASSWORD
> CHANGE DATE & TIME
=NEXT =SELECT
FACTORY DEFAULTS
Change Date & Time
CHANGE DATE & TIME
DAYLIGHT SVG TIME? Y
30-APR-03 10:56:30
=SELECT =NEXT/END
Setup System Info Menu
SETUP SYSTEM INFO
CHANGE PASSWORD
CHANGE DATE & TIME
=NEXT =SELECT
> FACTORY DEFAULTS
Factory Defaults
RESTORE ALL DEFAULTS
ARE YOU SURE? Y
=Y/N =END