Culligan Silver Series Owner's Manual page 19

Automatic water conditioner
Hide thumbs Also See for Silver Series:
Table of Contents

Advertisement

Performance Data Sheet
Culligan knows the more informed you are about your water treatment systems, the more confident you will be about its
performance. It's because of this and more than sixty years of commitment to customer satisfaction that Culligan is providing
this Performance Data Sheet to its customers.
IMPORTANT NOTICE: Read this Performance Data Sheet and compare the capabilities of this unit with your actual water
treatment needs. It is recommended that before purchasing a water treatment unit, you have your water supply tested to determine
your actual water treatment needs.
MANUFACTURER:
Culligan International Company,
One Culligan Parkway, Northbrook, IL 60062-6209 USA
(847) 205-6000
PRODUCT: Culligan Silver Series
USEPA SDWA
Substance
MCL
Barium
2 mg/L
Radium 226/228
5 pCi/L
TESTING CONDITIONS & RESULTS:
Flow Rate: 7.5 gpm
Pressure: 30 - 40 psi
Acidity: Non-Corrosive
Temperature: 68° (20°C)
pH:
pH:
pH: 7.6
pH:
pH:
SOFTENER SPECIFICATIONS:
Maximum Flow Rate: 7.5 gpm (30 Lpm)
Pressure Drop at Maximum Flow Rate: 15 psi (102 kPa)
Operating Temperature Range: : : : : 33 - 120°F (1 - 50°C)
Maximum Drain Flow Rate: 2.3 gpm (9 Lpm)
Working Pressure Range: 20 - 120 psi (140 - 860 kPa)
Operat
Operat
Operating Pressure Range (Canada):
Operat
Operat
ing Pressure Range (Canada): 20 - 90 psi (140 - 620 kPa)
ing Pressure Range (Canada):
ing Pressure Range (Canada):
ing Pressure Range (Canada):
The Culligan Silver Series Water Softeners are tested and validated by WQA and certified by UL against ANSI/NSF Standard 44 for
the effective reduction of calcium and magnesium (hardness) along with Barium and Radium 226/228*.
This softener is efficiency rated, it has a Demand Initiated Regeneration (D.I.R.) feature which complies with specific perfor-
mance specifications intended to minimize the amount of regenerant brine and water used in their operation. The softener has a
rated salt efficiency of not less than 3350 grains of total hardness exchange per pound of salt used (based on NaCl equavalency),
and shall not deliver more salt than its listed rating. The efficiency is measured by a laboratory test described in ANSI/NSF
Standard 44. This test represents the maximum possible efficiency that the system can achieve. Operational efficiency is the
actual efficiency achieved after the system has been installed. Operational efficiency is typically less than the efficiency due to
individual application factors including water hardness, water usage, and other contaminants that reduce the softener's capacity.
Refer to the Specifications, Familiarization and Warranty section of this Owner's Guide for more specific product information.
To avoid contamination from improper handling and installation, your system should only be installed and serviced by your
Culligan Man. Performance will vary based on local water conditions. The substances reduced by this system are not necessarily in
your water.
Culligan water softeners are designed to work with any salt of good quality, although it is recommended that you ask your local
Culligan Man for his suggestion on the best type and grade of salt to use in this softener.
NOTICE: This softener is not intended to be used for treating water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
† The efficiency rated dosage is only valid at the 4 lb salt dosage for 9" models.
*Verified utilizing hardness surrogate per ANSI/NSF Standard 44.
Buyer Signature _____________________________________________
Seller Signature _____________________________________________
9" Water Softener with Soft-Minder
SUBST
SUBST
ANCE REDUCTION
ANCE REDUCTION
SUBST
SUBSTANCE REDUCTION
SUBST
ANCE REDUCTION
ANCE REDUCTION
Reduction
80%
80%
Capacity:
17,500 grains @ 4.0 lb. salt
23,900 grains @ 8.0 lb. salt
26,600 grains @ 12.0 lb. salt
Efficiency Rated Dosage†: 4,380 gr/lb
Meter
®
Test Influent
Test Effluent
Concentration
Concentration
Level
Level
10 mg/L
2.0 mg/L
25 pCi/L
5 pCI/L
Date __________
Date __________
ANSI/NSF 44
Water Softener
81WN
17

Advertisement

Table of Contents
loading

Table of Contents