Table of Contents
Advertisement
COPYING A VIDEO TAPE
You can make copies of videotapes made by friends or
relatives for your own enjoyment.
WARNING:
Unauthorized recordings of copyrighted video
tapes may be an infringement of copyright laws.
Connect the recording VCR (this unit), playing VCR
(another VCR) and your TV as outline in the following
diagram.
1
Insert a pre-recorded video cassette into
the playing VCR.
2
Insert a blank video cassette, or one you
want to record over, into the cassette com-
partment of the recording DVD/VCR.
3
Press SPEED on the remote control to
select the desired recording speed (SP/LP).
4
Select "AV2" or "AV3" position on the
recording DVD/VCR.
See "OTHER CONNECTIONS" on page 14.
5
Press REC on the recording DVD/VCR.
6
Begin playback of the tape in the playback
VCR.
7
To stop recording, press STOP ( C ) on the
recording DVD/VCR, then stop playback of
the tape in the playing VCR.
Using scart jacks
(TV)
to 21-Pin
Scart Jack
AV2 (DECODER)
AERIAL
VCR
AV1 (TV)
DVD/VCR
AV1 (TV)
RF OUT
Using AV from terminals
Playing VCR
to the video output jack
Recording DVD/VCR (this unit)
Playing VCR
Recording DVD/VCR
(this unit)
DVD
S-VIDEO
ANALOG
DIGITAL
OUT
AUDIO OUT
AUDIO OUT
L
COAXIAL OPTICAL
R
to the audio output jack
CHANNEL
LINE 2
DVD OUTPUT VCR
TIMER
REC
VIDEO IN
L (mono) AUDIO IN R
to AV1 (TV)
Scart jack on
the back of the
DVD/VCR
to 21-Pin
Scart jack
(TV)
Notes
• For best results during dubbing, use the DVD/VCR's
front panel controls whenever possible. The remote
VCR
control might affect the playback DVD/VCR's oper-
ation.
• If video or colour fades in and out, you may be copy-
ing a copy guarded video tape.
TO MONITOR THE RECORDING
Turn on the TV and select the video channel on the TV.
A STATUS DISPLAY
To check the Counter, or Clock & Channel num-
ber, press DISPLAY. Each time you press the DIS-
PLAY, TV screen will change as illustrated:
When you select the channel using the remote control
number buttons, select the desired channel (position
number).
<OFF mode>
TV COLOUR SYSTEM
Different countries use different television colour sys-
tems. Tapes recorded in the PAL or NTSC system can
be played back on this unit. Usually, the picture on the
TV screen will be in black and white when you play
back a tape that is recorded in a different colour system.
• Tapes recorded in the NTSC system can be played
back on this unit and a PAL system TV set. This fea-
ture is only available in the SP mode. When playing
back such tapes, the picture may roll up or down,
shrink vertically and black bars may appear both at the
top and bottom of the screen. Adjust the vertical hold
control on your TV, if the TV features this control.
– 28 –
– 28 –
<COUNTER mode>
I
SP
Press once.
0:12:34
<CLOCK and CHANNEL
NUMBER mode>
I
SP
Press once.
VCR
Press once.
17:40
P02
VCR
EN
EN
2C15
2C15
Advertisement
Table of Contents
