VIDEO CHANNEL SETTING
Skip This Section When Connected By SCART.
Video channel setting will be necessary, if your
DVD/VCR is connected to the TV via the aerial cable.
• Use the remote control for this procedure.
1
Insert a pre-recorded tape into the
DVD/VCR.
• The DVD/VCR will turn on and start playback
automatically.
If playback does not start, press PLAY ( B) .
2
Select and adjust your TV to channel 35.
• If the playback picture appears on the TV screen,
continue with step 8.
• If channel 35 is employed for broadcasting, or
interference lines appear on the picture, the RF
converter must be set to a different channel
between CH22 and CH69. Continue with step 3.
3
Press MENU.
4
Press Arrow (
/p) repeatedly to select
o
"INITIAL". Then, press Arrow (
5
Press Arrow (
o
OUT". Then, press Arrow (
• The RF OUT CH menu will appear.
INITIAL
CH TUNING
CLOCK
RF OUT
6
Press Arrow (
which is not used for broadcasts between
channel 22 and channel 69 in your area, then
press Arrow (
B
7
Press MENU to exit.
• Set the TV channel to the RF OUT CHANNEL
which was selected on the DVD/VCR. Then, press
PLAY ( B) . A picture from the DVD/VCR will
appear on the TV screen. If a picture does not
appear, repeat steps 3 to 7 using a different channel
which is not used for broadcasts.
PRESET FOR USE
).
B
MENU
TIMER
SET UP
INITIAL
/p) repeatedly to select "RF
).
B
RF OUT CH 35
/p) to select a channel
o
).
8
Press STOP ( C ) to stop the tape.
Notes
• You may also access the RF OUT CH menu by
VCR
pressing and holding MENU on the remote control
for 3 seconds during power off until the RF OUT
CH menu appears.
• If your DVD/VCR and TV are connected using a
SCART cable there is no need to have the RF con-
verter operating so it can be switched off and avoid
the possibility of interference. To switch off the RF
converter, follow the instructions for Video Channel
Setting to step 6 then select channel 22 first and
then press Arrow (o/p) so that "--" appears next to
"RF OUT CH" on the TV screen and finally press
MENU to finish.
– 17 –
EN
2C15