Advertisement
Q!E%$
TTL/ANALoGuE
s~TcH
By pressing this switch, input signals can be selected between analogue and TTL.
* Avoid supplying both analogue and TTL signals at the same time since this may cause
interferences
between the signals (cross-talk).
Both connectors
can be connected at the
same time.
Q
HORIZONTAL
SIZE CONTROL
This controls the horizontal
size.
_
VERTICAL SIZE CONTROL
This controls the vertical size.
e
VERTICAL
CENTERING
CONTROL
This controls the vertical position of the data display.
/
-
16/64 COLOUR SELECT
When pressed in, the 64 colour mode is selected.
When set out, the 16 colour mode is selected.
When the AUTO mode is selected by the switch @
. This colour select does not work.
Instead, the monitor select 16 or 64 colour as standard
EGA monitor.
@@l?@
AuTo/MANuAL
SELECT
When it is pressed out, the auto mode is selected.
When the auto mode is selected, the
Multi 560 automatically
adjust to the IBM graphics board requirements
including Per-
sonal system/2.
When set in, the manual mode is selected.
The display size is proportional
to the signal. When the signal timing is differ from a fried
size, size controls 8 and 9 should be adjusted to obtain the required size. These controls
may not be capable for complete controls depending on the signal supplied.
_
TTL INPUT TERMINAL
Connect TTL output of the computer.
e
ANALOGUE ~p~
TE~~AL
Connect analogue output of the computer.
@@@
AC ~LET
Connect a suitable cord set for your power outlet.
Some units are supplied with a proper power cord.
Some are NOT.
@
TILT&
SWIVEL BASE
Refer to page 14.
7
Advertisement
