Advertisement
How to Remove or Install a Tdt /Swivel Stand
You can set the colour monitor to the desired angle with the tilt stand supplied.
CAUTION – This colour monitor may be used only with HITACHI exclusive tilt stand.
Use with other tilt stands may result in instability causing possible injury.
If you change the direction
of monitor
or operating
condition,
may cause impeTfect
colour uniformity
because of the influence of earth ma~etism.
This is not failure.
If you are worried about it, turn the power off and on again at an interval of 20-30
minutes or more after the power on to activate the internal auto degaussing.
(1) Install the tilt stand at the bottom of
the colour monitor.
(2) Fix the stand at 2 positions
using
screws.
14
Advertisement
