Installation Of Batteries - Hitachi AX-M68D Operating Instructions Manual

Installation of Batteries in the Remote Control
1. Remove the battery compartment cover.
2. Insert two batteries (size AAA) correctly so that the + and - polarities match the polarity diagrams in
the battery compartment.
* About half a year of normal operation can be expected when using batteries.
* When the batteries are exhausted, the remote will no longer operate the system. Replace both
batteries at the same time with new ones.
* Don't use an old battery with a new one.
* Don't use different types of batteries together.
* When the remote is not to be used for a long time period of time, remove the batteries to avoid
damage caused by battery leakage and corrosion.
Turning the Power On and Off
Turning the System On
Press the standby button (STANDBY) to turn the system on from standby mode. The display comes on.
Caution: When turning the system on, the system comes on ready to continue in the mode it was in
when last turned off.
Turning the System Off
Press the standby button (STANDBY) again to turning the system off (called Standby Mode).
Caution: Be sure to unplug the system from the wall output when going out or when the system is
not in use for an extended period of time.
- 5 -