Compaq DAT AutoLoader Reference Manual page 50

4-14 Compaq DAT AutoLoader Reference Guide
Table 4-1
LCD Messages - Alphabetical Listing
LCD Message Message
Type
Move Error
Medium
x => Mag
No Magazine Status
Read Status
Tape x
Ready Status
Ready Status
Tape x
Scan 1 Status
Scan 2, etc
Select Info
Prevent
Select x Info
Load
Tape x
Select x Info
Push ENT
Select x Info
Unload
Tape y
Send Diag Status
Checking
Mecha
continued
Meaning
Moves cassette x from the drive to the magazine, where x
represents the cassette number.
There is no magazine in the AutoLoader. The DAT AutoLoader
is ready for a magazine to be inserted.
Cassette x is being read.
x represents the number of the cassette.
A magazine has been loaded in the AutoLoader and the
Autoloader has completed scanning the cassettes and is
ready for operation.
Cassette x has been loaded into the drive and is ready for
operation. x represents the number of the cassette.
The DAT AutoLoader is examining the cassettes in the
magazine to check for proper magazine loading and
configuration.
This message is displayed if the SCSI command "PREVENT
MEDIA REMOVAL (LUN=0)" has been sent and the Select
button is pressed.
The cassette that has been selected is moving from the
magazine into the drive.
Pressing the Select button displays the message "Select x".
If Select is pressed again, x will increment to the next
cassette, else the "Push ENT" will also be displayed. To load
cassette x press the Enter button. If no button is pushed for a
couple seconds, the command is cancelled. x represents the
cassette number.
Cassette y is being returned to the magazine from the drive
so that cassette x can be loaded.
x and y represent different cassette numbers.
The diagnostics are checking the AutoLoader mechanics,
such as the elevator, and so on.
continued