Temperature Reporting - Clifford 570.4X Owner's Manual

Timer Start operation
Activation begins a countdown timer as set by the installer (de-
fault 3 hours). When the timer expires the engine starts and the
REMOTE START ON
Remote start runtime expires the engine shuts off, the
message is sent to the remote control and the countdown timer restarts.
This will repeat as many times as set by the installer (default 6 starts).
Timer Start is exited after the final start.
Smart Start operation
Smart Start uses the settings for Timer Start in addition to temperature
and battery level to automatically start the engine. Activation begins
the countdown timer. When the timer expires the vehicle interior tem-
perature and battery level is checked and, if the Temperature is above
100F, below 0F, or the battery level is below 10.5v, the engine will
start and the
controls. When the Remote start runtime expires the engine shuts off,
the
REMOTE START OFF
countdown timer restarts. Smart Start is exited after the final start.
Note
The temperature and battery thresholds can be changed by
an authorized Directed dealer if a higher or lower threshold
is desired.

Temperature Reporting

During Remote start the vehicle interior is checked regularly for tem-
perature changes. If a change in temperature is detected this report
will be sent to the remote for display. Each time the remote receives
this report it will beep, update, and display the newest temperature
information using the Temperature Gauge icon.
36 36
message is sent to the remote control. When the
REMOTE START ON
message is sent to the remote control and the
message will be sent to the remote
© 2011 Directed Electronics. All rights reserved.
REMOTE START OFF