Pin Door Lock Harness - Clarion UNGO MS8200 Installation Manual

3-Pin Door Lock Harness

Pin 1 - WHITE/green: Door Lock (-) / Door Unlock (+)
Pin 2 - **not used**
Pin 3 - WHITE/blue: Door Unlock (-) / Door Lock (+)
These wires can be directly connected to negative and positive triggered door lock systems.
For Voltage Reversal systems and After-market actuators, add relays.
information, see Door Lock Diagrams .
Closure, and 4-second pulse, see Programming and Jumper and Switch Settings .
4-Pin Optional Sensor Harness
Pin 1 - RED: +12v output.
Provides +12v to power optional sensor. Do not connect this wire to anything other than an
optional sensor or the Space Shield III, included with the MS8300.
Pin 2 - WHITE or WHITE/orange: Armed (-) output.
Provides ground to turn on the optional sensor only when the system is Armed.
Pin 3 - WHITE/violet: Optional Sensor (-) trigger input.
Connect to the negative trigger output from an optional sensor.
Pin 4 - VIOLET/ yellow: Warn Away (-) input.
Connect to the negative Warn Away output from an optional sensor.
Other Harnesses
For details on the Status LED and Override Switch, see Mounting Components .
Extra LEDs
Up to 3 extra LEDs can be added. Cut the Red LED wire and connect in series as shown.
LED
Connector
For selection of Double Pulse output, Comfort
MS8200 / MS8300 Installation Manual - Page 11
For further