Connecting A Tv Cable Or An Antenna - Hitachi L22H01 CB Instruction Manual

Connecting a TV Cable or an Antenna

Refer to the owner's manual of the external equipment to be connected. When connecting external
equipment, do not connect any AC power cords to wall outlets until you ha e completed all the
connections.
Basic Connection: Connecting an aerial
ON/OFF SWITCH
Connect your existing TV aerial to the Aerial input socket on the TV.
The Aerial input socket can be connected with the ATV/DTV Aerial.
A good quality outdoor aerial is recommended.
Insert the supplied mains cable to the mains socket located on the rear of the TV.
Connect the other end of this cable to the mains socket.
Connect all AC power sources before turning on the power switch at the back of the TV.
Turn the POWER SWITCH of rear TV on, and the red light will show on the front panel of the TV.
Press the STANDBY
The red light will change to blue light.
a. Press MENU button on the remote to enter Control Menu. Press
b. Press the OK button to confirm the entry of the submenu. Auto Installation will highlight in red,
then press OK button to confirm and input the PIN "0000" to the submenu. Press
to select your chosen country, and press OK to confirm the selection. Press
to start the search. Press OK to enter the submenu, then select YES and OK to start the scanning.
d. To power off press the STANDBY
Connect the AC IN
socket at back of the TV.
AC IN
TV Aerial
Aerial/75-ohm coaxial input
button on your remote to turn on your LCD TV.
button, and the
Unplug from a wall outlet
or to select SetUp.
or
button again
blue illuminated symbol will change to red.
13