Connection; Connecting Antenna Cable; Connecting External Equipment - Hitachi L42EC05AU User Manual

Connection

Connecting Antenna Cable

Connect the 75 ohm coaxial cable (commerically available) to the antenna input terminal.
To obtain better picture quality, use an outdoor antenna.
If your outdoor antenna uses 75 ohm coaxial cable with an F-type connector, connect it directly to the antenna input
terminal at the rear panel.
If your outdoor antenna uses flat cable, connect it with a 75 ohm adapter (commercially available) and then to the
antenna input terminal at the rear panel.

Connecting External Equipment

You can select the appropriate connection depending on the equipment that you are connecting and the
level of picture quality you are trying to achieve. To view external source images, press
source. ( page 15)
Please refer to the user manual of the external equipment for more information on the connection to the TV.
Please disconnect all the power supplies to the external equipment and TV before connection.
The illustration used here is based on model L32EC05AU. There may be a slight difference in the
illustration, if you are using model L42EC05AU.
To use HDMI terminal
or or
(rear)
If the external equipment has DVI output, you can connect it to the HDMI terminal using a HDMI-DVI
cable. In case of using the HDMI-DVI cable, connect analogue audio signal to RGB audio input terminal.
or
or
(rear)
To use Component Video terminal
(rear)
(side)
(side)
(side)
The HDMI cable connector should
not exceed 20mm in width (W) and
10mm in height (H).
HDMI OUT
DVI OUT
L
AUDIO
OUT
R
Y
COMPONENT
P
B
VIDEO OUT
P
R
L
AUDIO
OUT
R
to select input
W
H
HDMI Device
DVI Device
[Example]
DVD Player
13