Initial Settings; General Operation; Information Banner - Hitachi 42LDF30U Instructions For Use Manual

Initial Settings

When the TV set is operated for the fi rst time,
the IDTV turns on fi rst.
Because this is the fi rst time the TV is used,
there are no channels stored in the memory.
When the TV is turned on for the fi rst time, the
menu for the language selection appears on the
screen. The message "Welcome please select
your language!" is displayed in all language
options sequentially in the OSD.
By pressing the " " or " " buttons highlight
the language you want to set and press OK
button and then, "First time installation" OSD
will appear on the screen. By pressing " " or "
" buttons, select the country you want to set
and press button (** for EU countries).
Note: Country selection OSD will not be available
for UK.
After the "First time installation" is performed,
the following message appears on the screen:
To start installation process, select "Yes", to
cancel select "No".
• To select the "Yes" or "No" option, highlight the
item by using " " or " " buttons and press the
OK button.
The IDTV will automatically tune to the UHF or
VHF (** for EU countries) transmission channels,
searching for digital terrestrial TV broadcasts
and displaying the names of channels found.
This process will take about a few minutes. To
cancel searching, you can press the "M" button
at any time during the process.
After Automatic Search is completed, the
following message asking for analogue channel
search appears on the screen:
To search for analogue channels, select "Yes".
TV switches to the analogue TV mode. The
menu below is displayed to search for analogue
channels:
Select your Country, Language and Text
language by using " " or " " and " " or " "
buttons. Press OK or RED button to continue.
To cancel, press the BLUE button.
For more information on this process, see
"Install Menu" section.
Note: For proper functioning of digital teletext in DTV
mode, you should set country as UK in analogue
AUTO PROGRAM (for UK only).

General Operation

Pressing the "TV/DTV" button at any time
while watching television programmes will
switch the TV set between the digital terrestrial
television broadcasting and normal analogue
broadcasting.

Information Banner

• Whenever you change channel, using the
P- / P+ button or the numeric buttons, the TV
displays the broadcast picture along with an
information banner at the bottom of the screen
(available only in DTV mode). This will remain
on the screen for a few seconds.
English - 19 -