Switching The Tv On/Off; Navigating The Menu System; Initial Settings - Hitachi L26H01U Instructions For Use Manual

Switching The TV ON/OFF

To switch the TV on
Your TV will switch on in two steps:
1- Connect the power cord to the system. Press Power
On/Off switch. Then the TV switches itself to
stand-by mode (optional).
2- To switch on the TV from stand-by mode either:
Press a digit button on the remote control so that a
programme number is selected, or Press the “-P/CH”
or “P/CH+” button on the TV or press the P+ or P-
button on the remote control, so that last mode
switched off is selected.
By either method the TV will switch on.
To switch the TV off
• Press the “ (stand-by)” button on the remote con-
trol or On/Off switch on the TV, so the TV will switch
to stand-by mode.
To power down the TV completely, press On/Off
switch
or,
Unplug the power cord from the mains socket.

Navigating the Menu System

1- Press to display the menu.
_ `
2- Press / button to select an icon.
b
3- Use / button to highlight. Press
a
options in analogue TV mode. Use OK in DTV mode
for viewing a submenu.
_ `
4- Press / buttons to change the settings. Press
OK to set as default.
5- To exit the menu or return from sub-menu screen,
press .
These explanations are available for the navigation
of the whole menu system. To select options that are
explained in the following parts, refer to “Navigating
The Menu System”.
Downloaded From TV-Manual.com Manuals

Initial Settings

When the TV is turned on for the first time, it is in the
digital mode.
Because this is the first time the TV is used, there are
no channels stored in the memory and the following
message appears on the screen.
• To start installation process, select Yes, to cancel
select No.
• To select an option Yes or No, highlight the item by
_
using
The IDTV will automatically tune to the UHF transmision
channels 21 to 68 looking for digital terrestrial TV broad-
casts and displaying the names of channels found.
This process will take about five minutes. To cancel
searching, you can press the
during the process.
After Automatic Search process is completed, the
following message asking for analogue channel search
appears on the screen. TV switches to the analogue
TV mode.
`
for more
To seach for analogue channels, select Yes. The
menu below is displayed to search for analogue chan-
nels.
- 10 -
`
/ buttons and press the OK button.
button at any time