How To Install The Range Extender; Top View; Bottom View; Installation - Cisco RE1000 Getting Started Manual

RE1000 Range Extender
Top
Power Switch Only featured in the European versions of the
RE1000.
Reset
Press and hold this button for about eight seconds to
reset the extender to its factory defaults. You can also restore
the defaults from the Administration > Factory Defaults screen in
the extender's browser-based utility.
Wi-Fi Protected Setup Button
have client devices, such as wireless printers, that support
Wi-Fi Protected Setup, then you can use Wi-Fi Protected
Setup to automatically configure wireless security for your
wireless network. To use Wi-Fi Protected Setup, refer to
"Using Wi-Fi Protected Setup" on page 7.
Bottom
Ethernet (green) Using Ethernet cables (also called network
cables), this Ethernet port connects Ethernet network devices
to your wireless network.
The green light turns on when an Ethernet device is connected
and active on this port.
After initial setup, if you

How to install the range extender

1. Insert the Setup CD into a computer that is connected to the network
router. You will need to be near the router or access point and have
access to a networked computer.
IMPORTANT
Set up the extender close to the computer and router to ensure a
strong wireless signal. You can move it to a different location later.
2. When the Setup utility starts, read the license terms, then click Next. You
are prompted to plug your extender into an electrical outlet.
3. Connect your extender to an AC power outlet. Your extender searches for
wireless networks. The list of networks is displayed.
Getting Started
3