How To Install The Range Extener - Cisco Linksys RE1000 Getting Started

RE1000 Range Extener
Top
Power Switch Only feature in the European versions of the
RE1000.
Reset Press an hol this button for about eight secons to
reset the extener to its factory efaults. You can also restore
the efaults from the Administration > Factory Defaults screen in
the extener's browser-base utility.
Wi-Fi Protected Setup Button
have client evices, such as wireless printers, that support
Wi-Fi Protecte Setup, then you can use Wi-Fi Protecte
Setup to automatically configure wireless security for your
wireless network. To use Wi-Fi Protecte Setup, refer to
"Using Wi-Fi Protected Setup" on page 7.
Bottom
Ethernet (green) Using Ethernet cables (also calle network
cables), this Ethernet port connects Ethernet network evices
to your wireless network.
The green light turns on when an Ethernet evice is connecte
an active on this port.
After initial setup, if you
How to install the range extender
1. Insert the Setup CD into a computer that is connecte to the network
router. You will nee to be near the router or access point an have
access to a networke computer.
IMPORTANT
Set up the extener close to the computer an router to ensure a
strong wireless signal. You can move it to a ifferent location later.
2. When the Setup utility starts, rea the license terms, then click Next. You
are prompte to plug your extener into an electrical outlet.
3. Connect your extener to an AC power outlet. Your extener searches for
wireless networks. The list of networks is isplaye.
Getting Starte
3