Lightolier POINT POWER JACK Instructions For Maintenance Reference

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal
code specifications. To assure full compliance with codes and regulations, check with your local electrical
inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
NOTE: ACCESS ABOVE CEILING OR BEHIND WALL REQUIRED DURING INSTALLATION.
IF THE CEILING OR WALL IS MADE FROM A DENSE MATERIAL SUCH
AS 1/2" PLYWOOD OR 3/4" PLASTERBOARD AND IS FIRMLY
ATTACHED TO SUBSTANTIAL STRUCTURE THEN THE POINT POWER
JACK CAN BE MOUNTED DIRECTLY TO THE CEILING OR WALL AS
SHOWN BELOW.
(* IF THE CEILING OR WALL DOES NOT MEET THESE
REQUIREMENTS, USE T-BAR ACCESSORY NO.8618).
NOTE: THE MAXIMUM WATTAGE LABEL SELECTED FOR THIS
POWER JACK MUST CORRESPOND TO THE MARKINGS ON THE
TRANSFORMER LABEL.
1. Peel the appropriate MAXIMUM WATTAGE LABEL from its backing
and adhere it to the gap in the LABEL on the FLANGE of the
POINT POWER JACK (Fig. 1).
2. Select the CAP with the same MAXIMUM WATTAGE marking and
snap it over the FLANGE (Fig. 2).
NOTE: Use the 35W MAXIMUM WATTAGE LABEL and CAP for
fixtures that have screw-in adapters (Fig. 2).
POINT POWER JACK FOR 8600 LYTEJACK FIXTURES
POINT
POWER
JACK
FLANGE
GAP
LABEL ON BOTTOM
OF FLANGE
FIG. 1
FIG. 2
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720
INSTRUCTION SHEET NO.
IS:8605
A0300 Page 1of 1
LEADS (2)
SPRING TAB
MAXIMUM WATTAGE LABELS
ATTACH AT INSTALLATION
ATTACH AT INSTALLATION
CAPS
2
2000