Onkyo TX-NR626 Owner's Manual page 39

4
Press MEMORY again to store the station or
channel.
The station or channel is stored and the preset
number stops flashing.
Repeat this procedure for all of your favorite
AM/FM radio stations.
■
Selecting Presets
1
To select a preset, use PRESET
receiver, or the remote controller's CH +/–.
Tip
• You can also use the remote controller's number
buttons to select a preset directly.
■
Deleting Presets
1 Select the preset that you want to delete.
See the previous section.
2 While holding down MEMORY, press TUNING
MODE.
The preset is deleted and its number disappears
from the AV receiver's display.
Using RDS (excluding North American and
Taiwanese models)
When tuned into an RDS station, the RDS indicator
lights.
When the station is broadcasting text information, the
text can be displayed.
■
What is RDS?
RDS stands for Radio Data System and is a method
of transmitting data in FM radio signals. It was
developed by the European Broadcasting Union
(EBU) and is available in most European countries.
Many FM stations use it these days. In addition to
displaying text information, RDS can also help you
find radio stations by type (e.g., news, sport, rock,
etc.).
The AV receiver supports four types of RDS
/ on the AV
information:
PS (Program Service)
When tuned to an RDS station that's broadcasting PS
information, the station's name will be displayed.
Pressing DISPLAY will display the frequency for 3
seconds.
RT (Radio Text)
When tuned to an RDS station that's broadcasting
text information, the text will be shown on the AV
receiver's display.
PTY (Program Type)
This allows you to search for RDS radio stations by
type.
TP (Traffic Program)
This allows you to search for RDS radio stations that
broadcast traffic information
Note
• RDS works only in areas where RDS broadcasts are
available.
• In some cases, the text characters displayed on the AV
receiver may not be identical to those broadcast by the
radio station. Also, unexpected characters may be
displayed when unsupported characters are received. This
is not a malfunction.
• If the signal from an RDS station is weak, RDS data may be
displayed intermittently or not at all.
(➔ page 40).
En-39
■
Displaying Radio Text (RT)
1 Press RT/PTY/TP once.
The RT information scrolls across the AV
receiver's display.
Note
• The message "Waiting" may appear while the AV
receiver waits for the RT information.
• If the message "No Text Data" appears, no RT
information is available.
■
Finding Stations by Type (PTY)
You can search for radio stations by type.
1 Press RT/PTY/TP twice.
The current program type appears on the AV
receiver's display.
2
Use PRESET / to select the type of
program you want.
See the table shown later in this chapter.
3 To start the search, press ENTER.
The AV receiver searches until it finds a station of
the type you specified, at which point it stops
briefly before continuing with the search.
4
When a station you want to listen to is found,
press ENTER.
If no stations are found, the message "Not
Found" appears.
Playback