Connecting The Tv/Av Components - Onkyo TX-NR626 Owner's Manual

Connecting the TV/AV components

Before connecting the power cord, connect all of your speakers and AV components. To display the setup
menu on the TV screen, connecting the TV to HDMI OUT MAIN is required.
If you select the input selector button, the signal from
the component connected to the assigned jack is
played.
• Before making any AV connections, read the
manuals supplied with your AV components.
• Push plugs in all the way to make good connections
(loose connections can cause noise or
malfunctions).
• To prevent interference, keep audio and video
cables away from power cords and speaker cables.
Connections
Use this jack to connect to the HDMI input of the
TV. If your TV doesn't support Audio Return
Channel (ARC)
digital cable together with the HDMI cable to jack
Input
.
selector
Another TV can be connected to the HDMI OUT
buttons
SUB jack.
*1 ARC is the function that carries the audio signal
from the TV to jack
cable can connect the TV and the AV receiver.
Use this jack to connect to your Blu-ray Disc/DVD
player, etc.
, you need to connect an optical
*1
. With ARC, a single HDMI
En-15
Use this jack to connect to the Satellite/cable set-
top box, etc.
Use this jack to connect to the game consoles,
etc.
Use this port to connect to a LAN port on a router
so the AV receiver can be connected to your
home network.
Use jack and terminal here to connect the
supplied FM antenna and AM loop antenna.
Use this jack to make connections using an
analog audio cable.
With this connection, you can also enjoy analog
audio from external components while you are in
Zone 2.
Use this jack to make connections using a
component video cable.
Use this jack to connect to the camcorder/MHL-
enabled mobile device, etc.
Tip
• To listen to the audio of a component connected via HDMI
through your TV's speakers, enable "HDMI Through"
➔ page 65
( ) and set the AV receiver to standby mode.
• In the case of Blu-ray Disc/DVD players, if no sound is
output despite following the above-mentioned procedure,
set your Blu-ray Disc/DVD player's HDMI audio settings to
PCM.
• Connect a turntable (MM) that has a built-in phono preamp
to TV/CD IN, or connect it to PHONO IN with the phono
preamp turned off. If your turntable (MM) doesn't have a
phono preamp, connect it to PHONO IN. If your turntable
has a moving coil (MC) type cartridge, you'll need a
commercially available MC head amp or MC transformer to
connect to PHONO IN. See your turntable's manual for
details.
If your turntable has a ground wire, connect it to the AV
receiver's GND screw. With some turntables, connecting
the ground wire may produce an audible hum. If this
happens, disconnect it.
Connections