Connecting Onkyo Ri Components; Using Headphones - Onkyo TX-NR626 Owner's Manual

Connecting Onkyo RI Components

1
Make sure that each Onkyo component is
connected with an analog audio cable
(connection in the hookup examples)
(➔ page 15).
2
Make the connection (see the illustration).
3 If you're using an RI Dock, or cassette tape
deck, change the Input Display
With (Remote Interactive), you can use the
following special functions:
■
System On/Auto Power On
When you start playback on a component connected
via , while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected
via , the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver's remote controller to
control your other -capable Onkyo components,
pointing the remote controller at the AV receiver's
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(➔ page 72).
(➔ page 46).
e.g., cassette tape deck
Note
• Use only cables for
supplied with Onkyo components.
• Some components have two
either one to the AV receiver. The other jack is for
connecting additional
• Connect only Onkyo components to
other manufacturer's components may cause a
malfunction.
• Some components may not support all
to the manuals supplied with your Onkyo components.
• While Zone 2 is on, the System On/Auto Power On and
Direct Change
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
RI Dock
connections. cables are
jacks. You can connect
-capable components.
jacks. Connecting
functions. Refer
functions do not work.
En-20

Using Headphones

1
Connect a pair of stereo headphones with a
standard plug (1/4 inch or ø 6.3 mm) to the
PHONES jack.
While the headphones plug is inserted in the
PHONES jack, indicator lights.
Note
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the PHONES
jack, the speakers are turned off. (The Zone 2
speakers are not turned off.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it's already set to Stereo,
Mono, Direct, or Pure Audio (European, Australian
and Asian models).
Connections