Aerial Connection - Hitachi 26LD5550U User Manual

Aerial connection

Note: Before you connect other appliances:
• To avoid potentially damaging your set, make sure all items are switched off and disconnected from
the mains power when you make the connections.
• Arrange the desired connection.
• When you have fi nished making the connections, reconnect the mains power to the unit and switch it
back on.
Connect your aerial as shown below (C). Connections to other equipment is explained further on
P.27,28. If you have problems with reception, consult a specialist of aerial.
(K)
(H)
(A) HEADPHONE jack: Plug headphones with a mini plug (3.5 mm) into this jack.
(B) C.I. slot: for DVB-T-PayTV (still no providers at present) (see page 22).
(C) Aerial input socket: Connect the outdoor aerial to the aerial input socket as shown.
(D) HDMI input (HDMI1/HDMI2): See P.26.
(E) PC MONITOR input (PC): See P.25.
(F) PC/HDMI1 AUDIO input jack: See P.25, 26.
(G) Scart sockets (AV1/AV2): For the connection of scart cables. See P.27, 28.
(H) Digital audio output: Digital output for DVB-T sound (see page 28).
(I) COMPONENT input: See P.28.
(J) AV3 input: Input for analogue A/V-Signal (Composite). See P.28.
(K) Power supply: Connect the supplied power cable to an AC 220-240V/50/60Hz mains power supply
only - do not attempt to connect it to any other type of supply. Never try to repair a damaged AC
power cord with isolation-tape - this should be repaired by a specialist or replaced. Do not let your
pet loose near the cable. Animals biting into the cable could receive a fatal electric shock, and could
cause a hazard to others.
(L) Bracket holes: Fix a wall mounting bracket (not supplied) here.
10
(M) To hang the television on a wall, remove these screws and then remove a stand.
Before performing work spread cushioning over the base area to lay the TV on.
Back Side
(J) (I) (G)
(L)
(M)
(F) (E) (D)
(A)
(B)
(C)