Pc Connection - Hitachi 26LD5550U User Manual

PC connection

Follow these steps: On your PC monitor choose a resolution of 1280 x 768 at 60Hz and save this
confi guration. Shut down your PC and connect the shut off LCD TV.
Use a screensaver to avoid burning-in of static picture content.
Select PC input
Switch on the LCD-TV.
Select the PC input mode (see page 11).
Note:
• If no signal or a signal with a non-
supported resolution is connected, NO
SIGNAL is displayed
• As this LCD-TV is not a PC monitor
correct display cannot be guaranteed for
every PC / graphics card.
• Digital PC connection to HDMI-input is
not supported.
• If by any chance the PC should create
a picture on the HDMI-input then there
can be no guarantees for its correct
representation. Digital PC connection
is not an assured function of this TV
appliance.
• Select WXGA 'ON' in the menu
according to the following table:
Supported PC resolutions
WXGA resolution
OFF 640x480
OFF 720x400
OFF 800x600
OFF 1024x768
ON 1280x720
ON 1280x768
ON 1360x768
Description about the each setting option:
PICTURE Menu
BRIGHTNESS and CONTRAST: You can adjust
these according to your personal preferences.
HOR POSITION and VER POSITION: To adjust
the horizontal and vertical placing of the image.
PHASE and CLOCK: Eliminates the horizontal
(PHASE) and vertical (CLOCK) interfering lines
(Picture width).
RED/GREEN/BLUE: Infl uences the colour
balance.
BACKLIGHT: Press
require.
WXGA INPUT: When you input an WXGA signal,
set this option to "ON".
RESET: Press ENTER to reset BRIGHTNESS,
CONTRAST, RED, GREEN, BLUE and BACKLIGHT
to the factory preset values.
Use a PC-VGA cable (not supplied) to connect the LCD-
Monitor to your PC. Make the connections carefully so as not
to break or bend the contacts inside the plug.
Example: Adjust the contrast.
fps (Hz)
1
60
70
60
60
60
60
2
60
3
or to adjust the level you
TV
(Rear view)
to PC/HDMI1 AUDIO input
During PC mode press ANALOG
MENU.
The Menu will appear on the
screen.
Select CONTRAST, then press ENTER. Press
adjust CONTRAST.
Press EXIT to return to the normal screen.
AUDIO Menu
BASS/TREBLE/BALANCE: Tone setting menu.
SURROUND: Press
sound feature ON or OFF (see P. 17).
RESET: Press ENTER to reset BASS, TREBLE and
BALANCE to the factory preset values.
VGA Cable
(not supplied)
Audio cable
(not supplied)
BRIGHTNESS
CONTRAST
HOR POSITION
VER POSITION
PHASE
CLOCK
or to select surround
PC
25
50
0
0
25
0
or to
25