Start Up, Myscreen - Hitachi PJ-TX200 User Manual

Advanced Menu (SCREEN menu)
Item
START UP
MyScreen
(Continued on next page)
50
Using the ▲/▼ cursor buttons changes the start up image that is
displayed when no signal or an unsuitable signal is detected.
MyScreen  ORIGINAL  TURN OFF
 MyScreen
MyScreen is a feature which allows you to save a screenshot to
use in place of the default screen. Please refer to the description
of MyScreen ( Below) for information on saving a screen using
the MyScreen function. Until a screenshot is registered a plain
blue screen is displayed as the MyScreen image.
 ORIGINAL
When ORIGINAL is selected a factory pre-set start up screen is
displayed.
 TURN OFF
When TURN OFF is selected a plain black screen is displayed.
- NOTE -
• To prevent burn-in (burned in afterimage) the MyScreen and
ORIGINAL screens will switch to a plain black screen after several
minutes.
This projector has a MyScreen function which allows the user to
save a portion of an image to be used as the START UP image by
following the procedure below. See the description of START UP (
above) for information on selecting a START UP image.
First, input the signal and display the image you wish to save. Then,
in the SCREEN menu select the MyScreen item and press the
ENTER button or the ► cursor button.
(1) The "Do you start capturing this
picture?" dialog will be displayed.
Press the ENTER button and the
dialog will change and a frame to
select the portion of the image to
save will appear..
(2) Use the ▲/▼/◄/► cursor buttons
to move the frame and select the
portion of the image you wish to
save, then press the ENTER button.
The projector will then begin saving
the image (may take several
minutes).
(3) When the operation ends, a dialog will appear informing you of
the result.
Registration successful screen: ...
Error screen: ................................
- NOTE -
• The KEYSTONE cannot be adjusted while using the MyScreen
function.
Description
MyScreen
Do you start capturing this picture?
:NO :YES
RESET
MyScreen
Move the capture area
as you want.
:RETURN :NEXT RESET
MyScreen
▼
△
MyScreen registration is finished.
A capturing error has occurred.
ENTER
↓
ENTER
↓
45%
Please try again.