Using The Rating Setup Menu - Hitachi DVP425UK Instruction Manual

DVD Setup Menu Options
{ PCM }
Select this if the connected device is not capable of
decoding multichannel audio. The DVD player will
convert the Dolby Digital signal to PCM (Pulse Code
Modulation).
{ Off }
To deactivate the digital audio output. For example, if
you use the AUDIO OUT ( L/R ) jacks to connect to a
TV or stereo system.
B
Use / to select a setting and press OK to
Tip:
-When playing MPEG and set Digital Output to {ALL},
the player will output PCM signals.
Night Mode
This mode optimizes playback of sound at low
volume. High volume outputs will be softened and
low volume outputs are brought upward to an audible
level.
A
In 'Audio' , press /
then press .
{ On }
Select this to set low volume output. This feature
is only available for movie discs with Dolby Digital
mode.
{ Off }
Turns off night mode feature. Select this to enjoy the
surround sound with its full dynamic range.
B
Use / to select a setting and press OK to
Down Sampling
You can enable and disable the digital signal for
better sound output quality.
A
In 'Audio', press /
Sampling }, then press
{ Off }
PCM, select "Off ". Sound is sampled at 96 KHz.
{ On }
KHz PCM, select "On" . Sound recorded at 96 KHz is
down sampled to 48 KHz.
B
Use / to select a setting and press OK to
Tip:
- When playing back disc with copyright protection,
the sound will be down sampled to 48 KHz even
when you select Down Sampling off.
3D Effects
To obtain expansive virtual surround sound effects
from two speakers, set 3D Effects to on. This
enhancement sounds only for output from the Analog
AUDIO OUT (L / R) jacks of the DVD player.
A
In 'Audio', press /
press .You can set to { Off } or { On }.
B
Use / to select a setting and press OK to
Tip:
- Only effective in playback of a DVD Video disc with
Dolby Digital 5.1 bitstream.
to select { Night Mode },
to select { Down
.
to select { 3D Effects }, then

Using the Rating setup menu

A
Press SETUP on the remote control.
The system setup menu appears.
Parental control : 8.Aduit
Language
Set Password
Video
Audio
Rating
Misc
B
Press / to select {Rating }, then press
C
Press / to select an item, then press
access.
Example: { Parental control }
The options for the selected item appears.
If the selection in the menu is greyed out, that
means the feature is not available or not possible to
change at the current state.
D
Use / to select a setting and press OK to
Example: { 8 Adult }
The setting is selected and setup is completed.
E
To exit, press SETUP.
Rating Level settings
Depending on the DVD, you may be asked to
change the parental level while playing the disc. The
rating levels are from 1 to 8 and are country
dependent. You can prohibit the playing of certain
discs that are not suitable for your children, or have
certain discs played with alternative scenes.
A
In Rating , press /
then press .
B
Use the number buttons to enter the four-digit
password, then press OK.(See 'Changing the
Password' on page 21.)
C
Press OK again to list the parental level.
{ 1.Kid Safe }
Suitable for children.
{ 2. G }
General Audience; recommended as acceptable for
viewers of all ages.
{ 3. PG }
Parental Guidance suggested.
{ 4. PG-13 }
Unsuitable for children under 13.
{ 5. PG-R }
Parental Guidance Recommended.
{ 6. R }
Restricted; under 17 requires accompanying parent
or adult guardian.
{ 7. NC-17 }
No one under 17 admitted.
{ 8. Adult }
DVD softwares of any grades (adult/general/children)
can be played back. Should be viewed only by adults
due to graphic sexual material, violence or language.
D
Use / to select a rating level and press OK to
.
to
to select {Parental control },
20