Table of Contents
Advertisement
System Set-up
General Set-up
Finding the DVD Video Viewing Channel
I
1.
Press
STANDBY button on the DVD
player or the remote control to turn on the
unit.
2.
Turn on the TV and set it to the correct
VIDEO IN channel. Refer to the Instruction
Manual of your TV.
3.
Now, you should see the blue DVD
background screen.
4.
If you are using other external audio
equipment (for example stereo system or
audio receiver), please turn the volume
low and select the appropriate input
source for the DVD audio output. Refer to
your audio equipment's Instruction
Manual for details.
TIPS:
•
Usually these channels are between the
lowest and highest channels and may be
called FRONT, A/V IN, VIDEO. See your
TV's manual for more details.
•
Or, you may go to channel 1 on your TV,
then press the Channel down button
repeatedly until you see the Video In
channel.
•
Or, the TV remote control may have a
button or turn that chooses different video
modes.
•
Or, set the TV to channel 3 or 4 if you are
using an RF modulator.
Setting up the Progressive Scan
The progressive scan display twice the number
of frames per seconds than interlaced scanning
(common in ordinary TV system).
With nearly double the number of lines,
progressive scan offers higher picture resolution
and quality.
Before you start...
•
Ensure you have connected this DVD
player to a progressive scan TV with
YPbPr cable.
•
Ensure you have completed the basic
installation and set up.
I
1.
Press
STANDBY button on the DVD
and TV to power on.
GB-14
2.
Select the correct Video Input channel.
(i.e. you should see the blue DVD
background screen.)
3.
Press SETUP button on your DVD remote
control.
4.
Press
▲▼ buttons repeatedly to select
VIDEO, then press ► button.
TV SYSTEM
SCREEN SAVER
VIDEO
TV TYPE
PASSWORD
RATING
DEFAULT
5.
Select P-SCAN YPBPR, and press OK
button to confirm. The following menu will
appear on the TV.
6.
Press
◄ to highlight OK and press OK
button again to confirm.
7.
Turn on your TV progressive scan mode.
Refer to the Instruction Manual of your
TV.
8.
Now you will see the following menu on
the TV screen.
◄ to highlight OK and press OK
9.
Press
button to confirm.
The Progressive Scan set up is now completed.
To deactivate this feature, wait for 15 seconds
for the auto recovery or turn off the progressive
scan feature on both the DVD player and your
TV.
NOTE: There are some progressive scan TVs
and High-Definition TVs that are not fully
compatible with this unit, resulting in the
unnatural picture when playing back a
DVD VIDEO disc in the progressive scan
mode.
In such a case, turn off the progressive
scan feature on both the DVD player and
your TV.
INTERLACE-YUV
TV-RGB
P-SCAN YPBPR
Advertisement
Table of Contents
