Hitachi 42PD4200 User Manual page 29

OPERATING INSTRUCTIONS
Input Switching
• Input can be switched by pressing the AV1, AV2, AV3,
AV4, RGB1 or RGB2 buttons of the remote control. And
the way to return to a TV channel is as follows:
• Pressing INPUT SELECT button at RGB2 input screen.
• Pressing some PROGRAM SELECT buttons and select a TV
channel.
• Pressing PROGRAM UP/DOWN buttons at the screen without
OSD(On-screen display).
Size Switching
Each time the ZOOM button of the remote control is
pressed, the screen display size will change in sequence
and the status will be displayed at the bottom of the
screen.
• During VIDEO signal input (AV1, AV2, AV3)
Panoramic 4:3
14:9Zoom C14:9L
• The size will fix as Full mode and not change when receiving the
component signal of 1080i/50, 1080i/60 or 720p/60.
Full
Display size selection diagram
When you want to
Play a 4:3 image in a 16:9 screen faithfully.
Play a 4:3 image in a 16:9 screen with the
height and width of the middle of the
screen enlarged on equal scales and with
both sides appearing somewhat enlarged.
Play a 16:9 VISTA size image in the 4:3
image faithfully reproduced on the 16:9
screen.
Play a 4:3 image faithfully in a 16:9 screen
in the standard vertical size and
horizontally squeezed.*
Play a 14:9 image in a 16:9 screen
expanded vertically and squeezed
horizontally.
Play a 14:9 image expanded vertically on
the 16:9 screen.
Full
Zoom
Set the display size to Input signal
4 : 3
Panoramic
(4:3 signal)
Zoom
(Vista)
Full
(Squeeze)
C14 : 9L
(14:9 signal)
14 : 9Zoom
(14:9 signal)
D V D
1
4
7
RGB/VIDEO
AV1 AV2
buttons
Input can be switched in the sequence of TV ➔ AV1 ➔
•
AV2 ➔ AV3 ➔ AV4 ➔ RGB1 ➔ RGB2 by pressing the
INPUT SELECT button of the monitor or the remote
control.
TV AV1 AV2
RGB2 RGB1 AV4
• During AV4 signal input
Auto Full
14:9Zoom
• [Auto] is the mode using the Switch signal from the equipment
connected to AV4 terminal included in SCART connector No.8 pin
which indicate the picture format of the video source. When Switch
signal has not been detected, Default Zoom setting in the Function
Menu is used to choose.
• And during some input mode except AV4, if the Switch signal is
detected under the condition that [Auto] is selected for the picture
size of AV4, the input mode will automatically transfer to AV4.
Display screen
Blanking occurs on both sides.
• The 4:3 image is called a letterbox image.
• In some cases, some slight blanking may
remain at the top and bottom.
* An image with an aspect ratio of 16:9
shrunk horizontally to 4:3 to display in a 4:3
screen
This mode is provided for the broadcasting
program with WSS code-C14:9L.
This mode is provided for the broadcasting
program with WSS code-14:9Zoom.
FREEZE
ZOOM
ZOOM button
2 3
5 6
8 9
0
AV3 AV4
RGB1 RGB2
AV3
Zoom
C14:9L
Remarks
29