Video Unit Function - Hitachi 42PD4200 User Manual

Video Unit Function

INSTALLATION INSTRUCTIONS
Connecting to a Video Imaging Device
(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the imaging device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the imaging device.
VCR
To SCART
terminal
With DVI-STB and RGB component setup
Applicable video signals for each input terminal (See PRODUCT SPECIFICATIONS for details.
Terminal
Signal CVBS
AV1
AV2
AV3
AV4
RGB1
RGB2
28
20 18 16 14 12 10 8 6 4 2
21 19 17 15 13 11 9 7 5 3 1
Set-Top Box
To component video
equipments.
Please use the connection
cable suitable for the terminal
form of video equipment.
RCA/SCART
S-video Component RGB
Speaker (R)
Power
cord
To RGB,
video and audio
input terminals
[An example of connecting video imaging devices]
Use if the
video
equipment
has an
VCR
S video
input terminal
• If video equipment with an S video output terminal is used, cabling
by the S video cable is recommended to provide finer video
quality. (If the S video input terminal and the video input terminal of
AV3 connect to the monitor at the same time, S video input would
govern.)
• If the OUTPUT (MONITOR) terminal is connected to an external
monitor with a 75 Ohm terminal, it is possible to view the same
image as on the main unit. But it is possible to monitor only the
composite video signal from AV1, AV2, AV3, or AV4 input that is
displayed on the screen at the time.
DVI
PC STB RGB
Monitor rear panel
DVD player
D-sub
Component
Refer to Setup Menu.
Refer to Setup Menu.
Refer to Setup Menu.
Refer to Setup Menu.
Speaker (L)
DVD player
)
49
Remarks
35
35
36
36
( : Available)