Mitsubishi Electric MIM-A01 Instruction Manual page 37

Appendix
+ICF – Data Format
This Command sets data format of serial interface.
Command
AT+ICF?
AT+ICF=<format>,<parity>
Tab. 8-6:
Defined parameters:
<format>
1: 8 Data 2 Stop
2: 8 Data 1 Parity 1 Stop
3: 8 Data 1 Stop
If <format> is 1, 3, 4 or 6, <parity> will be ignored
+IFC – Flow Control
This Command determines flow control on serial interface.
Command
AT+IFC?
AT+IFC=<DCE_by_DTE>,<DTE_by_DCE>
Tab. 8-7:
Defined parameters:
< DCE_by_DTE >
0: none
2: RTS
Mitsubishi Industrial Modem
+ICF – Data Format
<parity>
0: Odd
1: Even
2: Mark
+IFC – Flow Control
< DTE_by_DCE >
0: none
2: CTS
Possible answers
+ICF: <format>,<parity>
OK
Note: current values
OK
<format>
4: 7 Data 2 Stop
5: 7 Data 1 Parity 1 Stop 4: None
6: 7 Data 1 Stop
Possible answers
+IFF: <DCE_by_DTE>,<DTE_by_DCE>
OK
Note: current values
OK
AT Commands MIM-G01
<parity>
3: Space
8 - 3