To choose the distance units
You can choose to display and enter distances in either feet and
inches, or metres.
To change the distance units:
Put the digital surround processor into standby by pressing
Off (front panel or remote).
Press and hold the V key on the front panel for at least five
seconds.
The display shows the distance
units:
or:
68
To start the calibration procedure
The display shows:
If you have an on-screen display it shows:
M e t r i c
I m p e r i a l
After a few seconds the display
shows:
For more detailed information about this and the other
calibration tests see the following sections.
Put the digital surround processor into standby by pressing
Off (front panel or remote).
Press and hold the Off key on the front panel for at least five
seconds.
C a l i b r a t i o n
L e f t
+ 0 . 0